Tire Changing Tool

SX4
SX4

SX4 SEDAN
SX4 SEDAN

The jack, wheel brace, jack handle are stowed in the luggage compartment.

To remove the spare tire, turn its bolt (1)


To remove the spare tire, turn its bolt (1) counterclockwise and remove it.

To remove the jack, turn its shaft counterclockwise


To remove the jack, turn its shaft counterclockwise and pull the jack out of the storage bracket.

SX4
SX4

SX4 SEDAN
SX4 SEDAN

To stow the jack, place it in the storage bracket and turn the shaft clockwise until the jack is securely held in place.

WARNING:
WARNING:
The jack should be used only to change wheels. It is important to read the jacking instructions in the “EMERGENCY SERVICE” section of this manual before attempting to use the jack.

WARNING:
WARNING:
After using the jack, jack handle and wheel wrench, be sure to stow them securely or they can cause injury if an accident occurs.

See also:

Highway Driving
When driving at highway speeds, pay attention to the following: • Stopping distance progressively increases with vehicle speed. Apply the brakes far enough ahead of the stopping point to allow ...

Driving Tips
WARNING: • Wear Your Seat Belts at All Times. Even though air bags are equipped at the front seating positions, the driver and all passengers should be properly restrained at all times, usi ...

Maintenance Schedule
The following table shows the times when you should perform regular maintenance on your vehicle. This table shows in miles, kilometers and months when you should perform inspections, adjustments, ...

Copyright © www.suzuguide.com