If you believe that your vehicle has a defect which could cause a crash or could cause injury or death, you should immediately inform the National Highway Traffic Safety Administration (NHTSA) in addition to notifying American Suzuki Motor Corp.
If NHTSA receives similar complaints, it may open an investigation, and if it finds that a safety defect exists in a group of vehicles, it may order a recall and remedy campaign. However, NHTSA cannot become involved in individual problems between you, your dealer, or American Suzuki Motor Corp.
To contact NHTSA, you may call the Vehicle Safety Hotline toll-free at 1- 888-327-4236 (TTY: 1-800-424-9153); go to http://www.safercar.gov; or write to: Administrator, NHTSA, 400 Seventh Street, SW., Washington, D.C.
20590. You can also obtain other information about motor vehicle safety from http://www.safercar.gov.
To contact American Suzuki, owners in the continental United States can call toll-free 1-800-934-0934, or write to:
American Suzuki Motor Corporation Automotive Customer Relations 3251 East Imperial Highway Brea, CA 92821-6795
For owners outside the continental United States, please refer to the distributor’s address listed in your Warranty Information booklet.
For vehicles registered for use and principally operated in Canada please contact Suzuki Canada Inc. at 1-905- 889-2677 extension 2254 or write to:
Suzuki Canada Inc.
Customer Relations
100 East Beaver Creek Road
Richmond Hill, On
L4B 1J6
Exterior & Styling
One good thing I can say about the Grand Vitara is that it's relatively
distinctive looking. It has some similarities to earlier-generation Saturn Vues,
and whether you like it or not is for you t ...
Vehicle Cleaning
WARNING:
When cleaning the interior or exterior
of the vehicle, NEVER USE flammable
solvents such lacquer thinners, gasoline,
benzene or cleaning materials
such as bleaches and strong hous ...
Mirrors
Inside Rearview Mirror
Inside Rearview Mirror
You can adjust the inside rearview mirror
by hand so as to see the rear of your vehicle
in the mirror. To adjust the mirror, set
the selector tab ...