
The interior light switch has three positions, which functions as described below.
(1) The light comes on and stays on regardless of whether the door is open or closed.
(2) The light comes on when the door is opened.
After closing all doors, the light will remain on for about 15 seconds and then fade out. If you insert the key into the ignition switch during that time, the light will start to fade out immediately.
After removing the key from the ignition switch, the light will turn on for about 15 seconds and then fade out.
(3) The light remains off even when the door is opened.

NOTE:
The number of doors involved in the lighting
operation of the interior light depends
on the vehicle specification. If there is a
switch (rubber projection) at the door
opening as shown, the door is involved in
the lighting operation. The tailgate of SX4
is also involved in this operation even without
the rubber projection.
Maintenance Recommended under Severe Driving Conditions
If the vehicle is usually used under the conditions corresponding to any
severe condition code given below, it is recommended that applicable
maintenance operation be performed at the particular in ...
Off-Road
We drove an RMZ-4 Equator around several trails at Knibbe Ranch, about 55
miles north of San Antonio. The ranch, consisting of 2,000 acres of Texas hill
country, is mostly covered with scrub oak a ...
2WD/i-AWD (intelligent All Wheel Drive) Switch (if equipped)
2WD/i-AWD (intelligent All Wheel Drive) Switch (if equipped)
The 2WD/i-AWD switch is located on the
center console.
For details on how to use the 2WD/i-AWD
switch, refer to “Using the 2WD/i-AW ...