Spark Plugs
Spark Plugs
Spark Plugs
You should inspect spark plugs periodically for carbon deposits. When carbon accumulates on a spark plug, a strong spark may not be produced. Remove carbon deposits with a wire or pin and adjust the spark plug gap.
To access the spark plugs: 1) Remove the engine cover.
2) Disconnect the coupler (1) while pushing the release lever.
3) Remove the bolt.
4) Pull the ignition coil out.
CAUTION:
When replacing spark plugs, you
should use the brand and type specified
for your vehicle. For the specified
plugs, refer to the
“SPECIFICATIONS” section at the
end of this book. If you wish to use a
brand of spark plug other than the
specified plugs, consult your SUZUKI
dealer.
See also:
Spark Plugs
Spark Plugs
65D180
You should inspect spark plugs periodically
for carbon deposits. When carbon accumulates
on a spark plug, a strong spark
may not be produced. Remove carbon
deposits with a w ...
Using the Transfer Switch (if equipped)
Using the Transfer Switch (if equipped)
Your vehicle is equipped with a four-mode
full-time 4x4 system. You can use the
transfer switch to select any of the four
modes: N, 4H, 4H LOCK, 4L LOCK.
...
Hazard Warning Switch
Hazard Warning Switch
Push in the hazard warning switch to activate
the hazard warning lights. All four turn
signal lights and both turn signal indicators
will flash simultaneously. To turn off ...