Tire Changing Tool
Tire Changing Tool
The jack, wheel brace and jack handle are stowed in the rear left corner of the luggage compartment. Remove the cover to access the tools.
To remove the jack, turn its shaft counterclockwise and pull the jack out of the storage bracket. To stow the jack, place it in the storage bracket and turn the shaft clockwise until the jack is securely held in place.
WARNING:
The jack should be used only to
change wheels. It is important to read
the jacking instructions in the
“EMERGENCY SERVICE” section of
this manual before attempting to use
the jack.
WARNING:
After using the jack, extension rod
and lug wrench, be sure to stow them
securely, or they could be thrown
about in an accident, causing injury.
See also:
Fog Light Switch (if equipped)
Fog Light Switch (if equipped)
The front fog light comes on when the fog
light switch is pushed in with the lighting
switch turned to the third position and the
beams set to the low beam positio ...
Vehicle Overview
The Equator arrived for 2009 as Suzuki's first venture into the compact
pickup market. The truck is built by Nissan and features mostly Frontier
hardware, but Suzuki had plenty of input in its sty ...
Maintenance Recommended under Severe Driving Conditions
If the vehicle is usually used under the conditions corresponding to any
severe condition code given below, it is recommended that applicable
maintenance operation be performed at the particular in ...