If you believe that your vehicle has a defect which could cause a crash or could cause injury or death, you should immediately inform the National Highway Traffic Safety Administration (NHTSA) in addition to notifying American Suzuki Motor Corp.
If NHTSA receives similar complaints, it may open an investigation, and if it finds that a safety defect exists in a group of vehicles, it may order a recall and remedy campaign. However, NHTSA cannot become involved in individual problems between you, your dealer, or American Suzuki Motor Corp.
To contact NHTSA, you may call the Vehicle Safety Hotline toll-free at 1- 888-327-4236 (TTY: 1-800-424-9153); go to http://www.safercar.gov; or write to: Administrator, NHTSA, 400 Seventh Street, SW., Washington, D.C.
20590. You can also obtain other information about motor vehicle safety from http://www.safercar.gov.
To contact American Suzuki, owners in the continental United States can call toll-free 1-800-934-0934, or write to:
American Suzuki Motor Corporation Automotive Customer Relations 3251 East Imperial Highway Brea, CA 92821-6795
For owners outside the continental United States, please refer to the distributor’s address listed in your Warranty Information booklet.
For vehicles registered for use and principally operated in Canada please contact Suzuki Canada Inc. at 1-905- 889-2677 extension 2254 or write to:
Suzuki Canada Inc.
Customer Relations
100 East Beaver Creek Road
Richmond Hill, On
L4B 1J6
Trunk Light (SX4 SEDAN)
Trunk Light (SX4 SEDAN)
When you open the trunk lid, the trunk light
comes on and remains on as long as you
keep the lid open.
CAUTION:
Do not leave the trunk lid open for a
long time, or the ...
Information Display
Information Display
(1) Clock.
(2) Thermometer.
(3) Instantaneous fuel consumption/Average fuel consumption/Driving range.
(4) “H” button.
(5) “M” button.
(6) “DISP” button.
(7) F ...
“PASS AIR BAG OFF” Indicator
“PASS AIR BAG OFF” Indicator
The “PASS AIR BAG OFF” indicator is
located on the center of the instrument
panel. When the ignition switch is turned to
the “ON” position, this indicato ...