Tire Changing Tool
SX4
SX4 SEDAN
The jack, wheel brace, jack handle are stowed in the luggage compartment.
To remove the spare tire, turn its bolt (1) counterclockwise and remove it.
To remove the jack, turn its shaft counterclockwise and pull the jack out of the storage bracket.
SX4
SX4 SEDAN
To stow the jack, place it in the storage bracket and turn the shaft clockwise until the jack is securely held in place.
WARNING:
The jack should be used only to
change wheels. It is important to read
the jacking instructions in the
“EMERGENCY SERVICE” section of
this manual before attempting to use
the jack.
WARNING:
After using the jack, jack handle and
wheel wrench, be sure to stow them
securely or they can cause injury if
an accident occurs.
See also:
Underfloor Bins (if equipped)
Pull up the straps (A) to open the bin.
CAUTION:
Do not allow items in the bins to
extend above the top of the bin. Otherwise,
the bin or luggage floor may
be damaged. ...
Maintenance Recommended under Severe Driving Conditions
If the vehicle is usually used under the conditions corresponding to any
severe condition code given below, it is recommended that applicable
maintenance operation be performed at the particular in ...
Driving on Slippery Roads
Driving on Slippery Roads
Under wet road conditions you should
drive at a lower speed than on dry roads
due to possible slippage of tires during
braking. When driving on icy, snow-covered,
or m ...