Head Restraints

Head Restraints
Head Restraints

Head restraints are designed to help reduce the risk of neck injuries in case of an accident.

Adjust the head restraint to the position which places the center of the head restraint closest to the top of your ears. If this is not possible for very tall passengers, adjust the head restraint as high as possible.

WARNING:
WARNING:
• Never drive the vehicle with the head restraints removed.

• Do not attempt to adjust the head restraint while driving.

Front
Front

To raise the head restraint, pull upward on the restraint until it clicks. To lower the restraint, push down on the restraint while holding in the release knob (1). If a head restraint must be removed (for cleaning, replacement, etc.), use the following procedure.

1) Insert a sharp-pointed tool into the small hole (2). Push the tip into the hole (2) and hold it while pushing in the release knob (1).

2) Pull the head restraint all the way out while pushing the release knob (1) and holding the tip in the hole (2).

NOTE:
It may be necessary to recline the seatback to provide enough overhead clearance to remove the head restraint.

To reinstall the head restraint, insert the


To reinstall the head restraint, insert the head restraint bars into the holes (2) and push the head restraint down.

Rear
Rear

To raise the rear head restraint, pull upward on the restraint until it clicks. To lower the restraint, push down on the restraint while holding in the release knob.

If a head restraint must be removed (for cleaning, replacement, etc.), push in the release knob and pull the head restraint all the way out.

When installing a child restraint system, raise the head restraint to the most upper position.

For SX4 SEDAN, if the distance between the child restraint system and the anchor bracket is too close to properly tighten the child restraint top strap, lower the head restraint to the lowest position and connect the top strap to the anchor bracket by passing it over the top of the head restraint.

NOTE:
It may be necessary to recline the seatback to provide enough overhead clearance to remove the head restraint.

See also:

Audio Systems
There are two types of audio system as shown below: Type 1 AM/FM/XM CD PLAYER WITH CD CHANGER CONTROL Type 2 AM/FM/XM 6-CD PLAYER WITH CD CHANGER CONTROL Precautions • When the inside o ...

Tires
For safe operation of your vehicle, it is important that the tires be the correct type and size, in good condition, and properly inflated. Be sure to follow the requirements and recommendations in ...

Emission Compliance Label (for U.S.A.)
Emission Compliance Label (for U.S.A.) The EPA emission compliance label is located under the hood. ...

Copyright © www.suzuguide.com