Rear Window Wiper/Washer Switch (if equipped)
To turn the rear wiper on, twist the rear wiper switch on the end of the lever forward to the “ON” position. If your vehicle is equipped the “INT” position, the rear wiper operates intermittently when you twist the switch forward to the “INT” position. To turn the rear wiper off, twist the switch rearward to the “OFF” position.
With the rear wiper in the “OFF” position, twist the switch rearward and hold it there to spray window washer fluid.
With the rear wiper in the “ON” position, turn the switch forward and hold it there to spray window washer fluid.
CAUTION:
Clear ice or snow from the rear window
and rear wiper blade before
using the rear wiper. Accumulated ice
or snow could prevent the wiper
blade from moving, causing damage
to the wiper motor.
See also:
Wiper Blades
Wiper Blades
If the wiper blades become brittle or damaged,
or make streaks when wiping,
replace the wiper blades.
To install new wiper blades, follow the procedures
below.
CAUTION:
To avoid ...
Radio Antenna
SX4
The radio antenna at the end of the roof is
removable. If the antenna hits anything
such as when parking in a garage with a
low ceiling, remove the antenna. Turn the
antenna counterclockwis ...
Windshield Wiper and Washer Lever
Windshield Wipers
To turn the windshield wipers on, move the
lever up and down to one of the four operating
positions. In the “INT” position (if
equipped), the wipers operate intermittently. ...