WARNING:
You should take extreme care when
working on your vehicle to prevent
accidental injury. Here are a few precautions
that you should be especially
careful to observe:
• To prevent damage or unintended
inflation of the air bag system, be
sure the battery is disconnected
and the ignition switch has been in
the “LOCK” position for at least 90
seconds before performing any
electrical service work on your
SUZUKI. Do not touch air bag system
components or wires. The
wires are wrapped with yellow tape
or yellow tubing, and the couplers
are yellow for easy identification.
• Do not leave the engine running in garages or other confined areas.
• When the engine is running, keep hands, clothing, tools and other objects away from the moving fan and drive belt.
• When it is necessary to do service work with the engine running, make sure that the parking brake is set fully and the transaxle is in Neutral (for manual transaxle vehicles) or Park (for automatic transaxle vehicles).
• Do not touch ignition wires or other ignition system parts when starting the engine or when the engine is running, or you could receive an electric shock.
• Be careful not to touch a hot engine, exhaust manifold and pipes, muffler, radiator and water hoses.
• Do not allow smoking, sparks or flames around gasoline or the battery.
Flammable fumes are present.
• Do not get under your vehicle if it is supported only with the portable jack provided in your vehicle.
• Be careful not to cause accidental short circuits between the positive and negative battery terminals.
• Keep used oil, engine coolant and
other fluids away from children and
pets. Dispose of used fluids properly;
never pour them on the
ground, into sewers, etc.
NOTICE (for U.S.A.) Maintenance, replacement or repair of the emission control devices and systems may be performed by any automobile repair establishment or individual using any part which has been certified under the provisions in the Clean Air Act sec. 207. (a) (2).
Bold and refined interior
The "X-over" design continues inside the vehicle, with curving wraparound
forms and trim materials and fabrics that have high visual and tactile quality.
Circular motifs and a flowing ce ...
Transfer Switch (if equipped)
Transfer Switch (if equipped)
The transfer switch is located on the center
of the instrument panel.
For details on how to use this switch, refer
to “Using the Transfer Switch” in the
“OPE ...
Brakes
Brake Fluid
Check the brake fluid level by looking at
the reservoir in the engine compartment.
Check that the fluid level is between the
“MAX” and “MIN” lines. If the brake fluid
level ...